Replacing The Mx240 Fan Tray; Removing The Mx240 Fan Tray - Juniper mx240 Hardware Manual
Universal edge router
Hide thumbs
Also See for mx240:
- Hardware manual (512 pages) ,
- Instruction for upgrading (35 pages) ,
- Quick start manual (31 pages)
Table of Contents
Advertisement
Replacing the MX240 Fan Tray
Removing the MX240 Fan Tray
Copyright © 2016, Juniper Networks, Inc.
Preventing Electrostatic Discharge Damage to an MX240 Router on page 416
Removing the MX240 Fan Tray on page 261
1.
2.
Installing the MX240 Normal-Capacity Fan Tray on page 262
NOTE:
To prevent overheating, install the replacement fan tray immediately
after removing the existing fan tray.
To remove the fan tray (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Loosen the captive screws on the fan tray faceplate.
2.
Grasp the fan tray handle, and pull it out approximately 1 to 3 inches.
3.
WARNING:
To avoid injury, keep tools and your fingers away from the fans
as you slide the fan tray out of the chassis. The fans might still be spinning.
Press the latch located on the inside of the fan tray to release it from the chassis.
4.
Place one hand under the fan tray to support it, and pull the fan tray completely out
5.
of the chassis.
Chapter 23: Replacing Cooling System Component
Figure 113 on page
262):
261
Advertisement
Table of Contents
Troubleshooting
