Installing An Mx240 As Msc; Figure 143: Removing An As Msc - Juniper mx240 Hardware Manual

MX240 3D Universal Edge Router Hardware Guide

Installing an MX240 AS MSC

310

Figure 143: Removing an AS MSC

To install an AS MSC (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Align the notches in the connector at the rear of the AS MSC with the notches in the
2.
AS MSC slot (slot —the top slot in the AS MLC ), and then slide the AS MSC in until
0
it lodges firmly in the AS MLC.
CAUTION: Slide the AS MSC straight into the slot to avoid damaging the
components on the bottom of the AS MSC.
Use one of the following methods to bring the AS MSC online:
3.
Press the AS MSC offline/online button until the LED light turns green.
Issue the following CLI command:
user@host> request chassis pic fpc-slot fpc-slot pic-slot pic-slot online
For more information about the command, see the
The normal functioning status LED confirms that the AS MSC is online. You can also
verify correct AS MSC functioning by issuing the
Figure 101 on page 243):
show chassis fpc pic-status
.
CLI Explorer
.
Copyright © 2016, Juniper Networks, Inc.