Related
Documentation
Connecting the MX240 Router to a Management Console or Auxiliary Device
Copyright © 2016, Juniper Networks, Inc.
Tools and Parts Required for MX240 Router Connections on page 205
Connecting DPC, MPC, MIC, or PIC Cables to the MX240 Router on page 211
To use a system console to configure and manage the Routing Engine, connect it to the
appropriate
port on the Routing Engine. To use a laptop, modem, or other
CONSOLE
auxiliary device, connect it to the
cable with an RJ-45 connector. One serial cable with an RJ-45 connector and a DB-9
connector is provided with the router. To connect a device to the
another device to the
AUX
To connect a management console or auxiliary device:
Turn off the power to the console or auxiliary device.
1.
Plug the RJ-45 end of the serial cable
2.
into the
port or
AUX
CONSOLE
the ports.
Plug the female DB-9 end into the device's serial port.
3.
NOTE:
For console devices, configure the serial port to the following values:
Baud rate—9600
Parity—N
Data bits—8
Stop bits—1
Flow control—none
Figure 82: Auxiliary and Console Ports
Figure 83: Routing Engine Console and Auxiliary Cable Connector
Chapter 18: Connecting the MX240 Router to the Network
port on the Routing Engine. Both ports accept a
AUX
port, you must supply an additional cable.
(Figure 78 on page 207
port on the Routing Engine.
CONSOLE
port and
shows the connector)
Figure 77 on page 207
shows
209