Installing An Mx240 As Mxc; Figure 145: Removing An As Mxc - Juniper mx240 Hardware Manual

Installing an MX240 AS MXC

Copyright © 2016, Juniper Networks, Inc.

Figure 145: Removing an AS MXC

To install an AS MXC (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Align the notches in the connector at the rear of the AS MXC with the notches in the
2.
AS MXC slot (slot 1—the bottom slot in the AS MLC), and then slide the AS MXC in
until it lodges firmly in the AS MLC.
CAUTION: Slide the AS MXC straight into the slot to avoid damaging the
components on the bottom of the AS MXC.
Use one of the following methods to bring the AS MXC online:
3.
Press the AS MXC offline/online button until the LED light turns green.
Issue the following CLI command:
user@host> request chassis pic fpc-slot fpc-slot pic-slot pic-slot online
For more information about the command, see the
Chapter 25: Replacing Line Card Components
Figure 102 on page 244):
CLI Explorer .
313