Connecting The Mx240 Router To A Network For Out-Of-Band Management; Figure 79: Alarm Relay Contacts; Figure 80: Ethernet Port; Figure 81: Routing Engine Ethernet Cable Connector - Juniper mx240 Hardware Manual

MX240 3D Universal Edge Router Hardware Guide
Related
Documentation

Connecting the MX240 Router to a Network for Out-of-Band Management

208
Plug the terminal block into the relay contact, and use a 2.5-mm flat-blade screwdriver
3.
to tighten the screws on the face of the block.
Attach the other end of the wires to the external device.
4.
To attach a reporting device for the other kind of alarm, repeat the procedure.

Figure 79: Alarm Relay Contacts

Tools and Parts Required for MX240 Router Connections on page 205
Connecting DPC, MPC, MIC, or PIC Cables to the MX240 Router on page 211
Connecting the Alarm Relay Wires to the MX240 Craft Interface on page 257
Routing Engine Interface Cable and Wire Specifications for MX Series Routers on
page 125
To connect the Routing Engine to a network for out-of-band management, connect an
Ethernet cable with RJ-45 connectors to the
Ethernet cable is provided with the router. To connect to the
Routing Engine:
Turn off the power to the management device.
1.
Plug one end of the Ethernet cable
2.
the port on the Routing Engine.
ETHERNET
Plug the other end of the cable into the network device.
3.

Figure 80: Ethernet Port

Figure 81: Routing Engine Ethernet Cable Connector

port on the Routing Engine. One
ETHERNET
ETHERNET
(Figure 76 on page 206 shows the connector) into
Figure 75 on page 206
Copyright © 2016, Juniper Networks, Inc.
port on the
shows the port.