Iat Sensor Inspection; Ap Sensor Inspection; Ap Sensor Removal And Installation; To Sensor Inspection - Suzuki GSX-R600 Manual

Installation
Install the IAT sensor in the reverse order of removal.
Pay attention to the following point:
• Tighten the IAT sensor screw (1) to the specified
torque.
Tightening torque
IAT sensor mounting screw (a): 1.3 N·m (0.13 kgf-
m, 1.0 lb-ft)

IAT Sensor Inspection

Refer to "DTC "C21" (P0110-H/L): IAT Sensor Circuit
Malfunction in Section 1A (Page 1A-57)".
Inspect the IAT sensor.
NOTE
IAT sensor resistance measurement method
is the same way as that of the ECT sensor.
Refer to "ECT Sensor Inspection (Page 1C-
5)".
CAUTION
!
• The IAT sensor operative temperature
range is –30 – 120 °C (–22 – 248 °F).
• Do not heat the oil up to 120 °C (248 °F) or
more for this inspection.
IAT sensor specification
Temperature
20 °C (68 °F)
40 °C (104 °F)
100 °C (212 °F)

AP Sensor Inspection

Refer to "DTC "C22" (P1450-H/L): AP Sensor Circuit
Malfunction in Section 1A (Page 1A-62)".
1
(a)
I837H1130016-01
B837H11306014
Standard resistance
Approx. 2.58 kΩ
Approx. 1.14 kΩ
Approx. 0.16 kΩ
B837H11306015
Engine Electrical Devices:

AP Sensor Removal and Installation

Removal
1) Remove the front seat. Refer to "Exterior Parts
Removal and Installation in Section 9D (Page 9D-
11)".
2) Disconnect the coupler and remove the AP sensor
(1).
Installation
Install the AP sensor in the reverse order of removal.

TO Sensor Inspection

Refer to "DTC "C23" (P1651-H/L): TO Sensor Circuit
Malfunction in Section 1A (Page 1A-71)".

TO Sensor Removal and Installation

Removal
1) Remove the front seat. Refer to "Exterior Parts
Removal and Installation in Section 9D (Page 9D-
11)".
2) Disconnect the coupler and remove the TO sensor
(1).
1C-6
B837H11306016
1
I837H1130017-01
B837H11306017
B837H11306018
1
I837H1130018-01