Suzuki GSX-R600 Manual page 427

5) After turning the mode select switch ON, turn the
ignition switch ON.
Special tool
(A): 09930–82720 (Mode select switch)
(A)
6) Check that the cable slots of the EXCVA pulley
comes to the middle (Adjustment position) "A".
7) Turn the ignition switch OFF.
CAUTION
!
Before removing the EXCVA, be sure to set
the EXCVA pulley to the adjustment position.
8) Disconnect the EXCVA position sensor coupler (1)
and motor coupler (2).
"A"
9) Remove the EXCV cables (3). Refer to "EXCV Cable
Removal and Installation (Page 1K-6)".
10) Remove the EXCVA (4).
I837H11B0026-01
2
1
I837H11B0027-01
4
3
I837H11B0028-02
11) Hold the pulley with an adjustable wrench, and
loosen the pulley mounting bolt (5).
CAUTION
!
• When loosening or tightening the pulley
bolt, be sure to fix the pulley with an
adjustable wrench, or EXCVA may get
damaged.
• Do not use the adjustable wrench to turn
EXCVA pulley so as not to cause damage
to the internal gear of EXCVA.
12) Remove the pulley from the EXCVA body.
Installation
Install the EXCVA in the reverse order of removal. Pay
attention to the following points:
• Install the EXCVA pulley to the shaft.
NOTE
Align the shaft's line "A" and cable slots "B".
Exhaust System:
5
I837H11B0029-02
"B"
"A"
I823H11B0017-02
1K-8