Suzuki GSX-R600 Manual page 430

1K-11 Exhaust System:
Step 4
1) To set the EXCV to fully opened position, apply 12 V
to the terminal oppositely.
Positive wire — Gr wire terminal
Negative wire — P wire terminal
CAUTION
!
To prevent the motor damage, stop applying
12 V as soon as the EXCV reaches fully
opened position.
2) Measure the position sensor output voltage at fully
opened position.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
(B): 09900–25009 (Needle pointed probe
set)
EXCVA position sensor out put voltage
EXCV is fully opened: 3.6 ≤ Output voltage ≤ 4.55
V ((+) Y – (–) W)
(A)
3) If the measured voltage is more than specification,
adjust the No. 2 cable adjuster as follows:
a) Set the EXCVA to the adjustment position. Refer
to "EXCV Cable Removal and Installation
(Page 1K-6)".
CAUTION
!
Adjusting the No. 2 cable with the EXCV fully
opened can damage the EXCVA. Be sure to
adjust the No. 2 cable with the EXCV set in
adjustment position.
b) Turn out the No. 2 cable adjuster (1) in or out to
4) After adjusting the EXCV cables, perform Step 2 to
confirm DTC "46" is not indicated.
Exhaust Pipe / Muffler Removal and Installation
Removal
1) Remove the right under cowling. Refer to "Exterior
Parts Removal and Installation in Section 9D
I837H11B0036-01
(Page 9D-11)".
2) Loosen the muffler connecting bolt (1).
(B)
3) Remove the muffler (2) by removing the mounting
bolt and nut (3).
NOTE
Support the muffler to prevent it from falling.
I837H11B0037-01
4) Remove the left under cowling. Refer to "Exterior
Parts Removal and Installation in Section 9D
(Page 9D-11)".
set the output voltage within the specified value.
3
1
I837H11B0038-01
B837H11B06002
1
I837H11B0001-01
2
I837H11B0002-01