1D-58 Engine Mechanical:
• Install each piston cooling oil jet.
NOTE
Apply a small quantity of thread lock to the
bolts and tighten them to the specified
torque.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Tightening torque
Piston cooling oil jet bolt (a): 10 N·m (1.0 kgf-m,
7.0 lb-ft)
Crankshaft
1) Apply molybdenum oil to each crank pin bearing
surface and crankshaft journal bearing surface.
2) Position the No. 2 and No. 3 conrod big ends on the
same side, and the No. 1 and No. 4 conrod big ends
on the opposite side of No. 2 and No. 3.
(a)
I837H1140135-02
I837H1140109-01
I837H1140110-01
3) Set the crankshaft to the conrods and upper
crankcase.
4) Apply engine molybdenum oil solution to crankpins
bearing surfaces.
CAUTION
!
Be sure to clean the conrod big end.
5) When fitting the conrod cap, make sure that I.D.
code "A" on each conrod faces intake side.
6) Apply engine oil to the conrod cap bolts.
I837H1140111-01
I837H1140112-01
"A"
I837H1140113-01