Suzuki GSX-R600 Manual page 336

1E-10 Engine Lubrication System:
Installation
Installation is in the reverse order of removal. Pay
attention to the following points:
• Fit the new O-ring (1) to each piston cooling oil jet and
apply engine oil to them.
CAUTION
!
Use the new O-rings to prevent oil pressure
leakage.
• Apply a small quantity of thread lock to the bolts and
tighten them to the specified torque.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Tightening torque
Piston cooling oil jet bolt (a): 10 N·m (1.0 kgf-m,
7.0 lb-ft)
1
I837H1150021-01
(a)
I837H1150022-01
Oil Jet (For Cam Chain Tension Adjuster)
Removal
1) Remove the throttle body. Refer to "Throttle Body
Removal and Installation in Section 1D (Page 1D-
10)".
2) Remove the cam chain tension adjuster (1). Refer to
"Engine Top Side Disassembly in Section 1D
(Page 1D-25)".
1
3) Remove the oil jet (2).
2
Installation
Installation is in the reverse order of removal. Pay
attention to the following points:
• Apply engine oil to the O-ring.
CAUTION
!
Use a new O-ring to prevent oil leakage.
I837H1150023-01
I837H1150024-01
I837H1150025-01