Suzuki GSX-R600 Manual page 409

4) Remove the starter idle gear No. 1 component parts
(2). Refer to "Starter Clutch Removal and Installation
in Section 1I (Page 1I-10)".
5) Remove the generator cover (3).
3
6) Remove the gasket (4) and dowel pin.
4
7) Remove the shaft (5) and starter idle gear No. 2 (6).
6
2
I837H11A0006-01
I837H11A0007-01
I837H11A0008-01
5
I837H11A0009-01
8) Hold the generator rotor with the special tool.
Special tool
(A): 09930–44520 (Rotor holder)
9) Remove the generator rotor bolt.
10) Install a bolt "A" of suitable size to the left end of
crankshaft.
11) Remove the generator rotor assembly (7) with the
special tool.
NOTE
Remove the starter clutch if necessary. Refer
to "Starter Clutch Removal and Installation in
Section 1I (Page 1I-10)".
Special tool
(B): 09930–34980 (Rotor remover)
(B)
"a": M12, length: 28 – 38 mm (1.1 – 1.5 in)
(B)
Charging System:
(A)
I837H11A0010-01
7
"A"
" a "
I837H11A0011-03
7
I837H11A0012-02
1J-5