Engine Assembly Removal - Suzuki GSX-R600 Manual

5) Click the "Reset" button (2) to clear the TP learned
value.
NOTE
The leaned value of the TP sensor is set at
Preset position.
6) Close the SDS tool and turn the ignition switch OFF.
NOTE
The TP sensor opening initialization is
automatically started after the ignition switch
is turned OFF position.

Engine Assembly Removal

Before taking the engine out of the frame, wash the
engine using a steam cleaner. Engine removal is
sequentially explained in the following steps:
1) Remove the under cowlings. Refer to "Exterior Parts
Removal and Installation in Section 9D (Page 9D-
11)".
2
I837H1140306-01
I837H1140307-01
B837H11406017
10) Remove the water bypass hose (3) and radiator inlet
2) Disconnect the battery (–) lead wire (1).
3) Jack up the motorcycle and fix it for safety.
4) Drain engine oil. Refer to "Engine Oil and Filter
Replacement in Section 0B (Page 0B-10)".
5) Drain engine coolant. Refer to "Engine Oil and Filter
Replacement in Section 0B (Page 0B-10)".
6) Lift and support the fuel tank. Refer to "Fuel Tank
Removal and Installation in Section 1G (Page 1G-
9)".
7) Remove the air cleaner box. Refer to "Air Cleaner
Box Removal and Installation (Page 1D-7)".
8) Remove the throttle body assembly. Refer to
"Throttle Body Removal and Installation (Page 1D-
10)".
9) Remove the radiator assembly (2). Refer to
"Radiator / Cooling Fan Motor Removal and
Installation in Section 1F (Page 1F-5)".
2
hose (4).
3
Engine Mechanical: 1D-19
1
I837H1140247-01
I837H1140284-01
4
I837H1140285-01