Multiplex Profi TX Operating Instructions Manual page 92

The menus
PROFI TX
Current time. An asterisk next to the time indicates that the alarm clock
4
function is activated.
The following warnings are displayed in capital letters.
MEMORY ERROR!
RANGE!
RF ERROR!
STUDENT MODE!
STUDENT
MULTIFLIGHT
5 Sensor display on status display #2
Displays the values for sensors 0, 1, and 15 if a receiver with downlink
is used. The value is shown crossed out if no sensor signal is received
for several seconds.
If the sensor reports an alarm:

The sensor value starts to flash.

The appropriate warning light for the sensor group below the screen
starts to flash (see section 2.1.1 " Top view" on page 23).

The device also starts to vibrate if the vibration alarm is activated
(see section 4.3.5.2 "Announce & Alert" on page 103).
If the sensor clears the alarm the value stops flashing. The vibration alarm
and warning light remain active until they are cleared by pressing the
ENTER button.
Notice: In other status displays the ENTER button has different
functions.
Displayed when errors occur while loading a
model memory. (page 163)
Transmitting power is reduced for the range
check. (page 95)
The RF component is defective.
The Student mode is enabled.
Only in Teacher mode: The selected control
functions are transferred to the student.
A MULTIFlight stick was detected: The mixers
on the servo side are switched off.
Page 89