Model Templates - Multiplex Profi TX Operating Instructions Manual

Model templates

3
PROFI TX
Model templates

Templates for fixed-wing models
BASIC, see page 58
ACRO, see page 61
GLIDER+, see page 61
DELTA WING, see page 67
FLYING WING, see page 69
BIG SCALE, see page 71

Templates for helicopter models:
FUNCOPTER, see page 75
HELI FBL, see page 76
HELImech., see page 77
HELIccpm, see page 77

Templates for land- or water-based models and tracked vehicles
CAR / TRUCK, see page 80
SHIP / BOAT, see page 82
TRACKED V., see page 84
Switch assignment
In the PROFI TX, all the switches can be installed and connected as needed.
For this reason, switched functions that are usually assigned to dip-switches
or buttons cannot be pre-set in the model templates. You have to configure
these assignments yourself according to the existing switches.
Using timers
The Frame, Sum, and Interval timers are only functional if a switch has been
assigned to them. The same control that is used for the Throttle control function
is assigned to the sum timer in all model templates. For this reason, this timer is
immediately functional. You activate the other timers by assigning a switch to them.
Control mixers (Ctrl.Mix)
The Ctrl.Mix control mixers are not initialised in the templates.
Seite 55