About These Operating Instructions - Multiplex Profi TX Operating Instructions Manual

Introduction
1.4
PROFI TX

About these operating instructions

These operating instructions describe the PROFI TX tray-type transmitter and
contain the following sections:

Section 1 "Introduction" provides an overview of the PROFI TX concept
and information regarding the current firmware version.

Section "Safety instructions" contains important information concerning
safety, intended use and warranty.

Section 2 "Transmitter" describes:
o
The PROFI TX hardware.
o
How to setup the transmitter for operation.
o
Mechanical operations that may have to be carried out on the
transmitter, e.g. installing additional controls.
o
How to charge the transmitter battery including battery
management.
o
How to switch the transmitter on and off.
o
How to perform a range check and the binding procedure.
o
How to operate in trainer mode.
o
How to trim your model aircraft.

Section 3 "Model templates" describes the model templates available in
the PROFI TX.

Section 4 "The menus" describes the PROFI TX software:
o
Navigation within the software.
o
The status displays.
o
All menus and their parameters.

Section 5 "Operating the transmitter" describes:
o
How to operate the transmitter by means of the keypad, the central
wheel and, if necessary, the optional digi-adjusters.
o
How to assign controls and switches. This defines which controls
are used to operate the various functions in the transmitter or
model.

Section 6 "Operating the transmitter using the PC" describes how
to connect the transmitter to the PC and the options provided by this
connection.

Section 7 "Creating and customising models" describes step by step
using two examples how to create and configure your own fixed-wing and
helicopter models.
Page 11