Operating The Transmitter Using The Pc; Connecting The Transmitter - Multiplex Profi TX Operating Instructions Manual

6
6.1
Page 176

Operating the transmitter using the PC

You can use the supplied USB cable to connect the PROFI TX to any PC or tablet
featuring an operating system that supports USB mass storage and an USB port
that is compliant with the USB standard (4.5-5.5V / 500mA). Some laptops and
tablets are not compliant with this standard.
The following functions are available when the transmitter is switched off
(charging mode):

Charging the battery; refer to section 2.4.1 "Charging the battery" on
page 40 for detailed information

Accessing the model memory on the SD card in the transmitter

Updating the PROFI TX software

Switching the transmitter on
The following functions are available when the transmitter is switched on
(normal mode):

Charging the battery

Controlling a model flying simulator

Switching the transmitter off

Connecting the transmitter

To connect the transmitter proceed as follows:
1. Lift the device (the recessed control for the
sliding latch is located on the underside of
the case).
2. Slide the latch to the left.
3. Connect the supplied USB cable to the mini
USB socket on the PROFI TX and to the USB socket on the PC.
Operating the transmitter using the PC
PROFI TX