Model Flying Simulator - Multiplex Profi TX Operating Instructions Manual

Operating the transmitter using the PC
6.5
PROFI TX

Model flying simulator

You can use the PROFI TX to control a model flying simulator in two ways:

Via USB cable

Via M-LINK in conjunction with the MULTIFlight stick
In both cases, you have the following options:

Would you like to work in simulator mode without configuring "Travel",
"Expo" and "Trim"?
Switch ON "Training" in the Setup > Training menu (see page 99).
Select the Student mode. In this case, only unprocessed stick signals are
used for controlling. It is not relevant which model memory is used. Only
the stick assignment must match (see "Ctrl Mode" on page 104).

Would you like to use "Trim", "D/R", "Expo", "Combi-Switch" and the
"Ctrl.Mix" mixers?
Create a new model using the BASIC template (page 159) and change the
model name (page 161), e.g. to Simulator. Safety check can be
switched off.
From now on, use this model memory for simulator mode.

Would you like to use "Expo", "D/R", "Trim", and "Combi-Switch" for the
simulator?
Create a new model memory based on the BASIC model template (page
159). Change the model name (page 161), e.g. to Simulator.
Alternatively, you can copy the memory of a suitable model. Change the
model name to avoid mix-ups. Do not use the memory of a real-world
model: Settings that you configure for the simulator mode will not
automatically suit your real-world model.
In simulator mode, all the functions on the servo side (mixers, curves, reverse)
are switched off.
Page 179