Table of Contents
Advertisement
Page 122
maximum control surface effectiveness, in the flight phase SPEED1 = 60% for
finer control.
Make sure to activate the desired flight phase first before making any changes!
Expo
Flight phase specific: -100% to +100%
The Expo parameter can be used to assign an exponential characteristic to
a control curve.
o
For Expo = 0%, the control works in a linear fashion.
o
The effect of negative Expo values is that the control generates
smaller control surface travels around the centre position providing
finer control.
o
The effect of positive Expo values is that control surface travels
are increased around the centre position.
o
The end-travels remain unchanged when Expo is used. So, full
travel is still available when required.
The menus
PROFI TX
Advertisement
Table of Contents
Need help?
Do you have a question about the Profi TX and is the answer not in the manual?
Questions and answers