Speech Output & Sounds; Volume; During Startup; Battery Monitor - Multiplex Profi TX Operating Instructions Manual

Speech output & sounds
8
8.1
8.2
8.3
8.4
8.5
8.6
PROFI TX
Speech output & sounds

Volume

The transmitter volume can be set by either choosing a fixed value or by
configuring a freely assignable control. The variometer volume is configured
separately. Refer to section 4.3.1 "Volume" on page 95 for details.

During startup

A tune can be played when the device is switched on. You can switch this feature
on or off in the Setup > Transmitter > Sounds menu (see page 114).

Battery monitor

You can use the Setup > Transmitter menu to set the time to empty value at
which the remaining operating time of the PROFI TX will start to be announced.
Refer to page 114 for details.

Announcing trim

You can have the device announce the trim position (increments) after trimming.
You can switch this option on or off in the Setup > Transmitter > Sounds
menu (see page 114).

Announcing flight phases

After switching to an enabled flight phase, the name of the flight phase is
announced. If the flight phase is disabled, the current flight phase is retained and
the message "flight phase disabled" is announced.

Announcing sensor values

You can enable the value of each of the 16 sensor channels for announcing (see
section 4.3.5.2 "Announce & Alert" on page 103.
The values of the enabled sensors are then announced in sequence in one block.
The break interval between the blocks can be set to a value between 30 and 180
seconds.
Page 209