Table of Contents
Advertisement
Page 198
Adjusting the maximum servo travel (control surface travel)
At this point, set the maximum required value for blade deflection; this is generally
the auto-rotation value. The smaller values required for normal flying can be set for
the individual flight phases in the ControlFunctions menu under Collective.
Open the Servo main menu.
1.
2. Open the Calibrate menu.
3. Select a servo.
4. Select the P1 menu item and open the parameter.
F
5. Press the
button. All the swashplate servos now assume this position.
This enables you to set the servo travel regardless of control position and trim.
F
Pressing the
button again enables the servos.
Maximum servo travel = ±110%
If required, servo travel can be increased to up to 110% on both sides.
6. Complete the calibration for P1.
7. Repeat the procedure for point P5, starting from step 4.
8. Exit the menu and set up the other servos accordingly.
Creating and customising models
PROFI TX
Advertisement
Table of Contents
Need help?
Do you have a question about the Profi TX and is the answer not in the manual?
Questions and answers