New Model - Multiplex Profi TX Operating Instructions Manual

The menus
4.8.3
PROFI TX
The name of the memory you have selected for copying is shown inverted and
in parentheses.
3. Move the memory to the target memory cell using the central wheel.
4. Copying is initiated by pressing the wheel or the ENTER button. Now, either
of the following cases is possible:
a. The target memory is empty: The model data is copied to the target
memory. The model name is applied.
b. The target memory is in use: You are prompted to confirm that you
wish to overwrite the memory.
Pressing REV/CLR:
Overwrites the existing memory with the copy.
Pressing ENTER or wheel:
Cancels copying; the target memory remains unchanged.
5. Now, you can copy further memories or close the menu using Exit.

New model

You can use the New model menu to create new model memories.
All the settings in this menu are retained, so, you do not have to re-enter the full
set of information for every new model memory.
Memory nr.
Data is automatically saved to the next empty memory cell in the transmitter.
It is not possible to choose at will. You can copy the model to a different
memory cell later (see section 4.8.2 "Copy" on page 158).
If all the memories are in use, the following information is displayed on screen:
Memory nr.-1
Page 159