Lldp Commands - D-Link DES-3028 Cli Reference Manual

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
The LLDP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command
enable lldp
disable lldp
config lldp
message_tx_interval
config lldp
message_tx_hold_multiplier
config lldp tx_delay
config lldp reinit_delay
config lldp
notification_interval
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp
forward_message
show lldp
show lldp mgt_addr
show lldp ports
show lldp local_ports
show lldp remote_ports
show lldp statistics
show lldp statistics ports
Parameters
<sec 5 - 32768 >
< int 2 - 10 >
< sec 1 - 8192 >
< sec 1 - 10 >
<sec 5 - 3600 >
[<portlist>|all] notification [enable | disable]
[<portlist>|all] admin_status [tx_only | rx_only | tx_and_rx |
disable]
[<portlist>|all] mgt_addr ipv4 <ipaddr> [enable | disable]
[<portlist>|all] basic_tlvs [all | {port_description |
system_name | system_description | system_capabilities}]
[enable | disable]
[<portlist>|all] dot1_tlv_pvid [enable | disable]
[<portlist>|all] dot1_tlv_vlan_name [vlan [all | <vlan_name
32> ] | vlanid <vidlist> ] [enable | disable]
[<portlist>|all] dot1_tlv_ protocol_identity[all | { eapol | lacp
| gvrp | stp }] [enable | disable]
config lldp ports [<portlist>|all]
{mac_phy_configuration_status
power_via_mdi | maximum_frame_size}] [enable | disable]
[enable | disable]
{ipv4 <ipaddr>}
{<portlist>}
{ <portlist>} {mode [brief | normal | detailed]}
{<portlist>} {mode [brief | normal | detailed]}
{<portlist>}
292
LLDP C
OMMANDS
dot3_tlvs [all
| link aggregation
43
|
|