Thermal Switch Inspection; Thermal Switch Removal And Installation - Suzuki 2006 SX4 Service Manual

f) Read stroke of armature plate from dial gauge by
performing step d) and e) repeatedly. (Stroke of
armature plate is clearance between armature
plate and magnet clutch pulley.)
Standard clearance between armature plate
and magnet clutch pulley:
0.3 – 0.5 mm (0.012 – 0.020 in.)
3
1
2

Thermal Switch Inspection

Measured thermal switch for resistance at 20 °C (68 °F)
Thermal switch resistance
Standard: 50 mΩ (DC 16 V, 5A at 20 °C (68 °F))
Air Conditioning System: Manual Type 7B-35

Thermal Switch Removal and Installation

Removal
1) Remove compressor from engine referring to
"Compressor Assembly Removal and Installation".
2) Disconnect thermal switch connector.
3) Remove magnet clutch lead wire clamp.
4) Remove thermal switch (1) from compressor using
flat head (2).
Installation
I4RS0A720046-01
Reverse removal procedure noting the following
instructions.
S6RW0D7216024
• Apply silicon sealant to contact face (2) of thermal
switch (1).
"A": Silicon sealant 99000–34220 (SUZUKI
SILICON SEALANT KE-347W (100g))
I7RW01721024-01
• Install compressor to vehicle referring to "Compressor
Assembly Removal and Installation".
• Evacuate and charge the A/C system referring to
"Evacuation" and "Charge" in "Operation Procedure
for Refrigerant Charge".
1
2
2, "A"
3
S6RW0D7216025
I5RS0C721011-01
1
I5RS0C721012-02