Right Case Disassembly And Reassembly - Suzuki 2006 SX4 Service Manual

5B-24 Manual Transmission/Transaxle:
16) Place left case plate (2) inserting its end in groove of
shift guide shaft (4) and then tighten bolts (1) to
which thread lock cement has been applied.
NOTE
After tightening bolts, make sure that
countershaft can be rotated by hand feeling
certain load.
"A": Thread lock cement 99000–32110 (Thread
Lock Cement Super 1322)
Tightening torque
Left case plate bolt (a): 23 N·m (2.3 kgf-m, 17.0
lb-ft)
3. Input shaft
5. Countershaft

Right Case Disassembly and Reassembly

Disassembly
1) Remove differential side oil seal from right case
referring to "Differential Side Oil Seal Replacement",
if necessary.
2) Remove differential side bearing outer race (1) using
brass bar (2), if necessary.
1
I2RH01520087-01
S6RW0D5206017
2
I4RH01520024-01
3) Remove input shaft oil seal by using special tool, if
necessary.
Special tool
(A): 09913–75830
(A)
4) Pull out countershaft right bearing outer race by
using special tools, if necessary.
Special tool
(A): 09930–30104
(B): 09941–64511
(B)
Reassembly
1) Install input shaft oil seal facing its spring side
upward until it becomes flush with case surface. Use
special tool and hammer for installation and apply
grease to oil seal lip.
: Grease 99000–25011 (SUZUKI Super Grease A)
Special tool
(A): 09913–76010
I5RW0A520026-01
(A)
I5RW0A520027-01
(A)
I5RW0A520028-01