Side Curtain-Air Bag (Inflator) Module Removal And Installation - Suzuki 2006 SX4 Service Manual

Side Curtain-Air Bag (Inflator) Module Removal
and Installation
WARNING
!
• Never attempt to disassemble or repair the
side curtain-air bag (inflator) module. If any
abnormality is found, be sure to replace it
with new one as an assembly.
• Be sure to read "Precautions on Service
and Diagnosis of Air Bag System",
"Precautions on Handling and Storage of
Air Bag System Components" and
"Precautions on Disposal of Air Bag and
Seat Belt Pretensioner" before starting to
work and observe every precaution during
work. Neglecting them may result in
personal injury or undeployment of the air
bag when necessary.
Removal
1) Disable air bag system. Refer to "Disabling Air Bag
System".
2) Remove head lining referring to "Head Lining
Removal and Installation in Section 9H".
3) Disconnect side curtain-air bag (inflator) module
connector (1) as shown in figure.
a) Unlock lock button (2).
b) With lock button unlocked, disconnect connector.
a)
b)
1
4) Remove side curtain-air bag (inflator) module fixing
bolts (1) and clips (2).
1
1
2
S6RW0D8206022
2
I5RW0A820075-01
1
1
2
I5RW0A820076-01
5) Remove side curtain-air bag (inflator) module.
WARNING
!
• When carrying a live air bag (inflator)
module, make sure the bag opening is
pointed away from you.
Never carry air bag (inflator) module by
wires or connector on the side of the
module. In case of an accidental
deployment, the bag will then deploy with
minimal chance of injury.
• As the live curtain air bag (inflator) module
must be kept with its bag facing up while
being stored or left standing. This is
necessary so that a free space is provided
to allow the air bag to expand in the
unlikely event of accidental deployment.
• Observe "Precautions on Handling and
Storage of Air Bag System Components"
for handling and storing it.
Otherwise, personal injury may result.
Installation
WARNING
!
Do not install side curtain-air bag (inflator)
module while twisted or bent. Otherwise, side
curtain-air bag (inflator) module may not
deploy and injury may result.
1) Install side curtain-air bag (inflator) module (1) with
clips (2) and new bolts (3).
2) Tighten side curtain-air bag (inflator) module
attaching bolts (4) to specified torque.
Tightening torque
Side curtain-air bag (inflator) module attaching
bolts (a): 11 N·m (1.1 kgf-m, 8.0 lb-ft)
1
3
3
2
4, (a)
Air Bag System: 8B-102
4, (a)
3
3
2
I5RW0A820077-01