Suzuki 2006 SX4 Service Manual page 1135

Removal
1) Disconnect negative (–) cable at battery.
2) Disable air bag system. Refer to "Disabling Air Bag
System".
3) Loosen driver air bag (inflator) module mounting
bolts (1) till it turns freely, pull them out and fix them
to bolt clamps.
4) Remove air bag (inflator) module from steering
wheel.
5) Disconnect driver air bag (inflator) module connector
(1) of driver air bag (inflator) module and horn
connector (2) (if equipped) as shown in figure.
a) Unlock lock button (3).
b) With lock button unlocked, disconnect connector.
1
2
WARNING
!
Special care is necessary when handling and
storing a live (undeployed) air bag (inflator)
module. Observe "Precautions on Handling
and Storage of Air Bag System
Components". Otherwise, personal injury
may result.
Installation
1) Connect horn connector (1) securely (if equipped).
2) Connect driver air bag (inflator) module connector
I3JA01820031-01
3) Install driver air bag (inflator) module (1) to steering
4) Make sure that clearance between module (1) and
5) Tighten driver air bag (inflator) module mounting bolt
3
a)
b)
I5RW0A820065-01
6) Enable air bag system. Refer to "Enabling Air Bag
7) Connect negative (–) cable at battery.
(2) to driver air bag (inflator) module (3) securely as
shown in figure.
a) Connect connector.
b) Lock connector with lock button.
2
1
wheel (2), taking care so that no part of wire harness
is caught between them.
steering wheel (2) is uniform all the way.
(left side) (3) to specified torque first and then driver
air bag (inflator) module mounting bolt (right side) (4)
to specified torque.
Tightening torque
Driver air bag (inflator) module mounting bolt
(a): 9 N·m (0.9 kgf-m, 6.5 lb-ft)
System".
Air Bag System: 8B-96
3
b)
a)
I5RW0A820066-01
I5RH01820103-01