G Sensor Removal And Installation (4Wd Model); G Sensor Inspection (4Wd Model) - Suzuki 2006 SX4 Service Manual

Hide thumbs Also See for 2006 SX4:

Table of Contents

G Sensor Removal and Installation (4WD Model)

• Do not drop and shock G sensor. It will

affect its original performance.

• Regarding G sensor removal and

installation, confirm specified torque and

use hand tool to avoid damage.

1) Disconnect negative (–) cable from battery.

2) Remove center console box.

3) Disconnect G sensor connector, and remove G

Installation

1) Install G sensor (1), and connect G sensor

Tightening torque

G sensor bolt (a): 3.0 N·m (0.3 kgf-m, 2.2 lb-ft)

2) Install center console box.

3) Connect negative cable to battery.

S6RW0D4506014

Connect positive cable of 12 V battery to "A" terminal of

sensor and ground cable to "C" terminal.

Then using voltmeter, check voltage between terminals

"B" and "C".

If measured voltage is not as specified, replace G

G sensor specification

When placed horizontally: 2 – 3 V

When placed upright with arrow upward: 3 – 4 V

When placed upright with arrow downward: 1 – 2 V

[A]: Horizontal

I5RW0A450027-01

[B]: Upright with arrow upward

I5RW0A450028-01

S6RW0D4506015

I5RW0A450029-01

[C]: Upright with arrow downward

Table of Contents