CAUTION
!
Upon completion of installation, note the
following.
• Sudden closing of door before adhesive is
completely set may cause glass to become
loose or to come off. Therefore, if door is
opened or closed before adhesive is
completely set, make sure to open all door
glasses and use proper care.
• If molding is not securely in place, hold it
down with a tape until adhesive is
completely set.
• Each adhesive has its own setting time.
• Be sure to refer to its maker's instruction,
check setting time of adhesive to be used
and observe precautions to be taken
before adhesive is set.
• Refrain from driving till adhesive is
completely set so as to ensure proper and
sufficient adhesion.
Front Pillar Window Components
1. Front pillar window glass
Front Pillar Window Removal and Installation
Refer to "Windshield Removal and Installation" as
preparation, removal and installation procedures are
basically the same. However, note the following.
• Observe the following precautions when applying
adhesive (1) along glass (2) edge.
• Adhesive (1) should be applied evenly especially in
height.
• Be careful not to damage primer (3).
• Press glass against body quickly after adhesive (1) is
applied.
Adhesive amount specification and position for front
pillar window
Height "a": 10 mm (0.39 in.)
Width "b": 6 mm (0.24 in.)
Position "c": 4.5 mm (0.18 in.)
Width "d": 12 mm (0.47 in.)
Position "e": 3.5 mm (0.14 in.)
Position "f": 5.5 mm (0.22 in.)
Width "g": 11.3 mm (0.44 in.)
S6RW0D9506003
4
1
1
"b"
I5RW0A950007-02
"b"
1
4. Molding
Glass / Windows / Mirrors:
3
"d"
"e"
"b"
3
2
"a"
"a"
2
"d"
3
"f"
4
"b"
9E-10
S6RW0D9506004
2
"d"
"c"
4
1
"a"
2
3
"g"
"c"
1
4
"a"
I5RW0A950008-01