Schematic And Routing Diagram; Body Electrical Control System Wiring Circuit Diagram - Suzuki 2006 SX4 Service Manual

10B-3 Body Electrical Control System:
When "B" mode is selected and the door is locked using keyless entry transmitter or door request switch, the theft
deterrent light (1) flashes at 0.1 second interval for 20 seconds and the security alarm system is set to the stand-by
mode (2). Once it is set to the stand-by mode, the theft deterrent light blinks at 2 second intervals.
When the system is set to stand-by mode and the door is unlocked by some way other than using keyless entry
transmitter or door request switch and opened or cut off BCM power supply voltage temporarily, the alarm devices
operate according to the selected mode as described above.
C
A
B
T1
A: Indicator light turned ON
B: Indicator light turned OFF
C: When door is locked using keyless entry transmitter or door request switch
The alarm stops under either of the following conditions.
• Ignition switch is turned ON
• A certain time has elapsed since the alarm started
For selection of the mode of the security alarm system, refer to "Security Alarm Mode Selection Procedure (If
Equipped)".
Input / Output Table
Input
Door request switch signal
Keyless entry transmitter
Door switch status
Door lock status
Ignition switch

Body Electrical Control System Wiring Circuit Diagram

NOTE
This wiring diagram shows circuits related to only BCM, not the entire circuits of BCM and junction
block. Refer to "Power Supply Diagram in Section 9A" for wiring circuits other than the figure below.
T3
T2 2

Schematic and Routing Diagram

T1: 0.1 seconds
T2: 20 seconds
T3: 2 seconds
Horn relay
Hazard warning relay
Warning buzzer
BCM
(located in BCM)
Theft deterrent light
(in information display)
1
I7RW01A20015-01
Output
I5RS0CA20003-01
S6RW0DA202001