A/C System Inspection At Ecm - Suzuki 2006 SX4 Service Manual

7B-12 Air Conditioning System: Manual Type
Manifold gauge MPa (kgf/cm
Lo
0.05 – 0.15 0.7 – 1.0
(0.5 – 1.5) (7 – 10)
(4.2 – 21.3) (100 – 142)
0.4 – 0.6
(4 – 6)
(56.9 – 85.3)
0.40 – 0.45 2.0 – 2.5
(4.0 – 4.5) (20 – 25)
(57 – 64) (285 – 355)
0.45 – 0.55
(4.5 – 5.5)
(64 – 78)

A/C System Inspection at ECM

When checking voltage at ECM terminals related to A/C system, refer to "Inspection of ECM and Its Circuits in Section
1A".
Condition
2 ) (psi)
Detail
Hi
Both low and high
pressure sides indicate
low readings.
Output air is slightly cold.
Pressure on low pressure
side is high.
Pressure on high pressure
side is low.
Both pressure becoming
equal right after A/C is
turned OFF.
High pressure reading on
both low and high
pressure sides.
High pressure reading on
both low and high
pressure sides.
Low pressure side tubing
is not cold when touched.
High pressure reading on
both low and high
pressure sides.
Large amount of frost or
dew on the low pressure
side tubing.
Possible cause
Insufficient refrigerant Using leak detector,
in system check for leaks and
(Refrigerant leaking). repair as necessary.
Recharge refrigerant to
a specified amount.
If the pressure reading
is almost 0 when the
manifold gauges are
attached, check for any
leaks, repair them, and
evacuate the system.
Internal leak in Inspect compressor
compressor. and repair or replace
as necessary.
Overcharged A/C Adjust refrigerant to
system. specified amount.
Faulty condenser Clean condenser.
cooling operation.
Faulty condenser Inspect and repair
cooling fan operation. condenser cooling fan.
Presence of air in A/C Replace desiccant and
system cap with filter.
(Improperly Inspect quantity of
evacuated). compressor oil and
presence of
contaminants in oil.
Evacuate system and
recharge with fresh
refrigerant.
Faulty expansion Replace expansion
valve. valve.
Refrigerant flow is not
regulated properly.
Correction
S6RW0D7214003