Specifications; Tightening Torque Specifications; Special Tools And Equipment; Recommended Service Material - Suzuki 2006 SX4 Service Manual

Installation
Install brake back plate by reversing removal procedure,
noting the instructions.
CAUTION
!
Never reuse rear wheel hub mounting bolts.
• Install rear wheel hub and brake back plate, and then
tighten mounting bolt. Refer to "Rear Drum Brake
Components".
• Install parking brake cable (1) to brake back plate.
Tightening torque
Parking cable cap nut (a): 11 N·m (1.1 kgf-m, 8.0
lb-ft)

Tightening Torque Specifications

Fastening part
Wheel cylinder mounting bolt
Rear brake pipe flare nut
Parking cable cap nut
NOTE
The specified tightening torque is also described in the following.
"Rear Drum Brake Components"
Reference:
For the tightening torque of fastener not specified in this section, refer to "Fasteners Information in Section 0A".

Recommended Service Material

NOTE
Required service material is also described in the following.
"Rear Drum Brake Components"
• After installing all removed parts, bleed air from brake

Specifications

N⋅m
12
16
11

Special Tools and Equipment

1
(a)
system referring to "Air Bleeding of Brake System in
Section 4A". and then adjust parking brake cable
referring to "Parking Brake Inspection and Adjustment
in Section 4D".
Tightening torque
kgf-m lb-ft
1.2 9.0
1.6 11.5
1.1 8.0
Rear Brakes: 4C-6
I4RS0A430024-01
S6RW0D4307001
Note
S6RW0D4308001