Rear Fog Light Switch Inspection (If Equipped) - Suzuki 2006 SX4 Service Manual

9B-27 Lighting Systems:
2) Check to see if hot spot (high intensity zone) of each
front fog light axis falls as shown in the figure.
NOTE
If the fog lights interfere each other and make
it hard to see the cut line clearly, cover the
fog light on one side. This helps to make
aiming adjustment easier.
Hot spot specification
Angle "b": 1.14° (Specification)
Calculated distance "H": Approx. 199 mm (7.83
in.)
3) If it is not set properly, align front fog light to
specification by rotating aiming gear.
1
"b"
"H"
A
2 "H"
X
[A]
A
7
2. Bounding line
3. Hot spot
4. Aiming gear (for up / down adjustment)
5. Turning (for up adjustment)
6. Turning (for down adjustment)
7. Front fog light assembly
X-X: Horizontal center line of front fog light bulb
A-A: Vertical center line of left front fog light bulb
B-B: Vertical center line of right front fog light bulb
[A]: Left front fog light
[B]: Right front fog light
"a"
B
2
"H"
X
[B]
3
B
7
4
5
6
I6RW0C920020-01

Rear Fog Light Switch Inspection (If Equipped)

NOTE
• Rear fog light switch can be turned to ON
position only when headlight switch is
turned to HEADLIGHT position (low or high
beams).
• Rear fog light switch turns OFF
automatically when headlight switch is
turned to OFF position.
Check for continuity between terminals at each switch
position.
If check result is not as specified, replace switch.
ON
OFF
1 2
Terminal
Shaft condition
OFF
ON
S6RW0D9206021
1 2
I4RS0B920013-01