8. Air intake control actuator
HVAC Unit Removal and Installation
Refer to "HVAC Unit Removal and Installation".
Temperature Control Actuator Removal and
Installation
Removal
1) Disconnect negative (–) cable at battery.
2) Remove steering column hole cover from instrument
panel.
3) Remove driver side foot duct from HVAC unit.
4) Disconnect temperature control actuator connector
(1).
5) Remove temperature control actuator (2) from HVAC
unit by removing screws (3).
2
3
16. Evaporator temperature
sensor
S6RW0D7226003
S6RW0D7226004
1
3
I7RW01722018-01
Air Conditioning System: Automatic Type 7B-81
24. Temperature control door
assembly
Installation
Reverse removal procedure noting the following
instructions.
• Before installing actuator, make sure that position of
actuator lever is in between "MAX HOT" position and
"MAX COOL" position.
• Be sure to insert pin (1) of temperature control
actuator into the groove (2) of link.
Temperature Control Actuator and Its Circuit
Inspection
1) Remove temperature control actuator from HVAC
unit referring to "Temperature Control Actuator
Removal and Installation".
2) Connect connector to temperature control actuator.
3) Set temperature selector to "MAX COOL" position
with ignition switch turned ON.
4) Connect voltage meter between terminal "2" and
body ground.
5) Turn temperature selector to "MAX HOT" position.
1
2
I7RW01722019-01
S6RW0D7226005