Suzuki 2006 SX4 Service Manual page 1443

6
4
3
5
2
WARNING
!
Handling of rear end door balancer (damper)
• Handle balancer carefully. Do not scar or
scratch exposed surface of its piston rod,
and never allow any paint or oil to stick to
its surface.
• Do not turn piston rod with balancer fully
extended.
• Do not disassemble balancer (1) because
its cylinder is filled with gas.
Discarding of rear end door balancer
(damper)
• The gas itself in balancer is harmless but it
may issue out of the hole together with
chips generated by the drill (2). Therefore,
be sure to wear goggle when drilling.
• Using a 2 to 3 mm (0.08 to 0.12 in.) drill (2),
make a hole to remove gas inside as
shown before discarding.
1
A
A
A
A
A
A
A
B
A
A
A
4
2
A B
I5RW0A9A0008-03
I2RH019A0010-01
Hood / Fenders / Doors:
Installation
Reverse removal procedure noting the following.
• Tighten rear end door balancer bolt to specified
torque.
Tightening torque
Rear end door balancer bolt (a): 23 N·m (2.3 kgf-
m, 17.0 lb-ft)
• Secure wiring harness (1).
• Adjust door latch striker position by referring to "Rear
End Door Lock Assembly Removal and Installation in
Section 9F".
• Adjust door cushion so that door contacts body when
closed.
• Apply sealant to contact face "A" of door hinge (1) and
apply grease to rotating part "B" of hinge (1).
Specified sealant and grease.
"A": Sealant 99000–31110 (SUZUKI Bond
No.1215)
"B": Grease 99000–25011 (SUZUKI Super Grease
A)
(a)
(a)
I5RW0A9A0009-02
1
I5RW0A9A0010-01
I2RH019A1012-01
9J-7