Contact Coil Cable Assembly Removal And Installation - Suzuki 2006 SX4 Service Manual

6B-5 Steering Wheel and Column:
4) Connect horn connector and audio control switch
connector, if necessary.
5) Install driver air bag (inflator) module to steering
wheel. Refer to "Driver Air Bag (Inflator) Module
Removal and Installation in Section 8B".
6) Connect negative (–) cable to battery.
7) Enable air bag system referring to "Enabling Air Bag
System in Section 8B".
Contact Coil Cable Assembly Removal and
Installation
CAUTION
!
Do not turn contact coil more than allowable
number of turns (about two and a half turns
from the center position clockwise or
counterclockwise respectively), or coil will
break.
Removal
1) Disconnect negative (–) cable at battery.
2) Disable air bag system referring to "Disabling Air
Bag System in Section 8B".
3) Remove steering wheel from steering column
referring to "Steering Wheel Removal and
Installation".
4) Remove steering column hole cover.
5) Remove steering column lower cover (2) and upper
cover (1).
2
S6RW0D6206003
1
I6RW0B620005-01
6) Remove contact coil cable assembly (1) from
steering column.
Installation
1) Check to make sure that vehicle's front tires are set
at straight-ahead position and then ignition switch is
at LOCK position.
2) Install contact coil cable assembly to steering
column securely.
NOTE
New contact coil cable assembly is supplied
with contact coil set and held at its center
position with a lock pin (1). Remove this lock
pin after installing contact coil cable
assembly to steering column.
1
I6RW0B620009-02
I4RS0A620010-01