Dtc B1044: Passenger Air Bag Circuit Shorted To Power Supply - Suzuki 2006 SX4 Service Manual

Step
3 Floor harness circuit check
1) Disconnect "L377" connector located near the
passenger side front pillar lower trim.
2) Check for proper connection to floor harness connector
at terminal in "L377" connector.
3) If OK, release shorting bar in SDM connector inserting
release tool (1) included in special tool (A).
Special tool
(A): 09932–76010
4) Measure resistance between "L377-1" terminal and body
ground, and between "L377-2" terminal and body
ground.
"L04-5"
Is each measured resistance infinity?
NOTE
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components and ensure all components are properly mounted.
• Clear DTCs referring to "DTC Clearance", if any.
• Repeat "Air Bag Diagnostic System Check" to confirm that the trouble has been corrected.

DTC B1044: Passenger Air Bag Circuit Shorted to Power Supply

Wiring Diagram
Refer to "DTC B1041: Passenger Air Bag Circuit High Resistance".
DTC Detecting Condition and Trouble Area
DTC detecting condition
Passenger air bag circuit has been shorted to power
supply for more than 4 sec.
DTC Troubleshooting
Step
1 Was "Air Bag Diagnostic System Check Flow" performed?
Action
"L04-6"
(A)
1, (A)
Action
Yes
Repair "BLU/RED"
circuit or "YEL/RED"
circuit for short to
ground at instrument
panel harness.
I7RW01822046-01
• Passenger air bag circuit
• SDM
Yes
Go to Step 2.
Air Bag System:
No
Repair "BLU/RED"
circuit or "YEL/RED"
circuit for short to
ground at floor harness.
S6RW0D8204025
Trouble area
No
Go to "Air Bag
Diagnostic System
Check Flow".
8B-46