Turn Signal Light Switch (In Lighting Switch) Removal And Installation; Turn Signal Light Switch (In Lighting Switch) Inspection; Turn Signal And Hazard Warning Relay Removal And Installation - Suzuki 2006 SX4 Service Manual

Turn Signal Light Switch (in Lighting Switch)
Removal and Installation
For removal and Installation, refer to "Headlight Switch
(in Lighting Switch) Removal and Installation".
Turn Signal Light Switch (in Lighting Switch)
Inspection
Check for continuity between terminals at each switch
position. If check result is not as specified, replace
switch.
N
[A]
1 2 3
[C]
[D]
N
[A]: Other than RHD without rear for light
[B]: RHD without rear fog light
[C]: Terminal
[D]: Switch position
S6RW0D9206009
S6RW0D9206010
[B]
1 2 3
1 2 3
I5JB0D920018-01
Turn Signal and Hazard Warning Relay Removal
and Installation
Removal
1) Disconnect negative (–) cable at battery.
2) Remove junction block assembly (1) referring to
"BCM (Included in Junction Block) Removal and
Installation in Section 10B".
3) Remove turn signal and hazard warning relay (2).
1
Installation
Reverse removal procedure for installation.
Lighting Systems: 9B-24
S6RW0D9206011
2
I7RW01920008-01