Rear Wiper Removal And Installation - Suzuki 2006 SX4 Service Manual

9D-6 Wipers / Washers:

Rear Wiper Removal and Installation

Removal
1) Disconnect negative (–) cable at battery.
2) Remove arm cover (1), rear wiper arm nut (2), rear
wiper arm with blade assembly (3), rear wiper pivot
cap (4), rear wiper nut (5) and rear wiper seal (6).
1
2
3
4
3) Remove rear end door trim referring to "Rear End
Door Lock Assembly Removal and Installation in
Section 9F".
4) Disconnect coupler from rear wiper motor.
5) Remove rear wiper motor.
Installation
1) Install rear wiper motor (1) and tighten rear wiper
motor mounting bolts to specified torque.
Tightening torque
Rear wiper motor mounting bolt (a): 8 N·m (0.8
kgf-m, 6.0 lb-ft)
S6RW0D9406006
5
6
I4RS0A940013-01
(a)
1
I5RW0A940011-01
2) Connect coupler to rear wiper motor
3) Install rear end door trim referring to "Rear End Door
Lock Assembly Removal and Installation in Section
9F".
4) Install rear wiper seal (1), and tighten rear wiper nut
to specified torque.
Tightening torque
Rear wiper nut (a): 5 N·m (0.5 kgf-m, 4.0 lb-ft)
5) Install rear wiper pivot cap (2).
2
(a)
1
6) Install rear wiper arm with blade assembly (1) to
specified position as shown in figure.
3
a
2. Rear wiper blade
3. Ceramic line
7) Tighten rear wiper arm nut to specified torque, and
then install arm cover (1).
Tightening torque
Rear wiper arm nut (a): 8 N·m (0.8 kgf-m, 6.0 lb-
ft)
1
(a)
8) Connect negative (–) cable to battery.
I4RS0A940015-01
1
2
b
3
a = b
I5RW0A940012-01
I4RS0A940017-01