Suzuki 2006 SX4 Service Manual page 1104

8B-65 Air Bag System:
Step
3 Floor harness circuit check
1) Disconnect applicable "L384" or "L385" connector under
front cushion.
2) Check for proper connection to applicable floor harness
connector at terminal in connector "L384" or "L385".
3) If OK, release shorting bar in SDM connector inserting
release tool (1) included in special tool (A).
Special tool
(A): 09932–76010
4) With ignition switch turned ON, measure voltage
between "L04-11" terminal and body ground, and
between "L04-12" terminal and body ground (for DTC
B1064).
5) Measure voltage between "L04-13" terminal and body
ground, and between "L04-14" terminal and body ground
(for DTC B1068).
"L04-11" "L04-12" "L04-13" "L04-14"
(A)
Is each measured voltage 0 V?
NOTE
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components, ensure all components are properly mounted.
• Clear DTCs referring to "DTC Clearance", if any.
• Repeat "Air Bag Diagnostic System Check" to confirm that the trouble has been corrected.
Action
"L384", "L385"
1,(A)
I7RW01822085-01
Yes
DTC B1064: Repair
"BLU" circuit or "BLK"
circuit for short to power
supply circuit at driver
side-air bag harness.
DTC B1068: Repair
"BLU" circuit or "BLK"
circuit for short to power
supply circuit at
passenger side-air bag
harness.
No
DTC B1064: Repair
"GRY/RED" circuit or
"GRY" circuit for short to
power supply circuit at
floor harness.
DTC B1068: Repair
"BRN/WHT" circuit or
"BRN" circuit for short to
power supply circuit at
floor harness.