Suzuki 2006 SX4 Service Manual page 797

26) Apply A/T fluid to 2nd brake piston assembly (1), and
align the projection of 2nd brake piston assembly
with the groove of transaxle case, then put together.
27) Install 2nd brake piston snap ring (1) by using
special tool and hydraulic press.
CAUTION
!
Do not damage 2nd brake piston assembly,
return spring subassembly, plates and discs
by pressing in 2nd brake assembly passing
through its original installing position over
0.4 mm (0.016 in.).
Special tool
(A): 09926–96050
28) Check 2nd brake piston stroke by measuring
clearance between 2nd brake separator plate (1)
and piston (2) with feeler gauge (3).
If clearance, that is, piston stroke is out of
specification replace clutch discs and plates with
new ones.
CAUTION
!
When brake disc, retaining plate and/or
separator plate of 2nd brake have been
replaced, all learned contents, which have
been stored in TCM memory by executing
learning control, should be initialized
referring to "Learning Control Initialization".
Neglecting this initialization may cause
excessive shift shock.
Automatic Transmission/Transaxle:
2nd brake piston stroke
Standard: 0.40 – 1.25 mm (0.016 – 0.049 in.)
I2RH0B510282-01
29) After applying A/T fluid to front sun gear thrust
bearing race (2), install it to front planetary sun gear
(1).
I2RH0B510283-01
30) Apply A/T fluid to front planetary sun gear (1) and
install it to planetary gear assembly (2).
2
1
3
5A-149
I2RH0B510284-01
I2RH0B510285-01
I2RH0B510286-01