Differential Side Oil Seal Replacement - Suzuki 2006 SX4 Service Manual

Differential Side Oil Seal Replacement

1) Lift up vehicle and drain transaxle oil.
2) Remove drive shaft assembly and center shaft
referring to "Front Drive Shaft Assembly Removal
and Installation in Section 3A".
3) Remove oil seal (1) by using special tool.
Special tool
(A): 09913–50121
(A)
4) Install a new oil seal (1) by using special tool.
NOTE
• When installing oil seal, face its spring
side inward.
• Install oil seal horizontally to surface of
case.
Special tool
(A): 09913–75810
(B): 09913–75510
Distance between case and right oil seal for 2WD
"a": 9.5 – 10.5 mm (0.37 – 0.41 in.)
Distance between case and left oil seal
"b": 0 – 1.0 mm (0 – 0.04 in.)
5) Apply grease to oil seal lip and at the same time
S6RW0D5206003 check drive shaft where oil seal contacts and make
sure of its smoothness.
"A": Grease 99000–25011 (SUZUKI Super
Grease A)
6) Insert drive shaft assembly and center shaft referring
to "Front Drive Shaft Assembly Removal and
1 Installation in Section 3A".
I5RW0A520006-02
7) Pour transaxle oil referring to "Manual Transaxle Oil
Change".
Manual Transmission/Transaxle:
"b"
(B)
1, "A"
5B-7
(A)
"a"
I5RW0A520051-01