Suzuki 2006 SX4 Service Manual page 449

4) Drive in dust cover so that dimensions "a" and "b"
become equal as shown in the figure.
CAUTION
!
When drive in dust cover, be careful not to
deform it.
5) Caulk more than 6 places with a punch.
6) Using special tool and hydraulic press, press fit
wheel hub (1) into wheel bearing (2) (Face grooved
rubber seal side to wheel hub).
Special tool
(A): 09913–75510
7) Apply grease lightly to end face of inner ring (1).
"A": Grease 99000–25121 (SUZUKI Super
Grease H)
NOTE
Do not apply the grease to the encoder
section to avoid the encoder malfunction.
I2RH01220038-01
8) Install steering knuckle with wheel hub and bearing
(1) so that foreign material should not enter wheel
speed sensing point "a".
I2RH01220039-01
I7RW01220007-01
Front Suspension:
2. Wheel encoder
3. Drive shaft
2B-12
I5RW0B220001-01
I7RW01220008-02