Suzuki 2006 SX4 Service Manual page 316

1D-34 Engine Mechanical:
Installation
1) Install tappets and shims to cylinder head.
Apply engine oil around tappet and then install it to
cylinder head.
NOTE
When installing shim, make sure to direct
shim No. side toward tappet.
2) For engine with VVT, install camshaft bearings (1) to
cylinder head (2) and camshaft housing (3).
CAUTION
!
Do not apply engine oil to camshaft bearing
back.
Only a upper half bearing of intake camshaft
bearing No.1 has some holes.
3) Install intake camshaft (1) and exhaust camshaft (2).
Align knock pin (3) and match mark (4) with notches
(5) as shown in figure.
NOTE
Before installing camshafts, turn crankshaft
until key position faces upward.
Refer to "Timing Chain and Chain Tensioner
Removal and Installation".
I2RH0B140075-01
[A]: For engine with VVT
[B]: For engine without VVT
4) Apply engine oil to sliding surface of each camshaft
and camshaft journal then install them as shown in
figure.
5) Install camshaft housing pins (1) as shown in figure.
I5RW0C140024-01
[A]
1
3
5
[B]
1
"b"
4
5
"a": Approx. 30°
"b": Approx. 60°
2
"a"
4
2
"a"
4
I4RS0B140015-01
I3RM0A140033-01