Suzuki 2006 SX4 Service Manual page 354

1D-72 Engine Mechanical:
Fastening part
Cylinder head bolt for M10
Connecting rod bearing cap nut
Sensor plate bolt
Main bearing cap No.1 bolt
Main bearing cap No.2 bolt
Rear oil seal housing bolt
Flywheel or drive plate bolt
NOTE
The specified tightening torque is also described in the following.
"Air Intake System Components"
"Engine Mountings Components"
"Timing Chain Cover Components"
"Timing Chain and Chain Tensioner Components"
"Camshaft, Tappet and Shim Components"
"Valves and Cylinder Head Components"
"Pistons, Piston Rings, Connecting Rods and Cylinders Components"
"Main Bearings, Crankshaft and Cylinder Block Components"
Reference:
For the tightening torque of fastener not specified in this section, refer to "Fasteners Information in Section 0A".
Tightening torque
N⋅m kgf-m
Tighten 20 N⋅m (2.0 kgf-m, 14.5 lb-ft), 40
N⋅m (4.0 kgf-m, 29.0 lb-ft), 60° and 60° by
the specified procedure
Tighten 15 N⋅m (1.5 kgf-m, 11.0 lb-ft), 45°
and 45° by the specified procedure
11 1.1
Tighten 30 N⋅m (3.0 kgf-m, 22.0 lb-ft), 50
N⋅m (5.0 kgf-m, 36.5 lb-ft) and 60° by the
specified procedure
Tighten 25 N⋅m (2.5 kgf-m, 18.0 lb-ft) by the
specified procedure
11 1.1
70 7.0
Note
lb-ft
/
8.0
/ /
/ /
8.0
51.0