Suzuki 2006 SX4 Service Manual page 317

6) Check position of camshaft housings.
Embossed marks are provided on each camshaft
housing, indicating position and direction for
installation. Install housings as indicated by these
marks.
A: I: Intake side or E: Exhaust side
B: Position from timing chain side
C: Pointing to timing chain side
7) After applying engine oil to housing bolts, tighten
them temporarily first. Tighten bolts evenly and
gradually in numerical order ("1" through "21") by
repeating tightening sequence two or three times
until specified torque is obtained.
Tightening torque
Camshaft housing bolt (a): Tighten 11 N⋅m (1.1
kgf-m, 8.0 lb-ft) by the specified procedure
"10" "9" "2" "1",(a) "6" "5"
"20"
"17"
"19"
"18"
"21"
"12" "11" "4" "3"
I2RH0B140078-01
"14" "13"
"8" "7" "16" "15"
I3RH0B140041-01
8) For engine with VVT, with hexagonal section (1) of
intake camshaft (2) held stationary with spanner or
the like, tighten bolt of intake cam timing sprocket
assembly (3) to specification.
Tightening torque
Intake cam timing sprocket bolt (a): 60 N·m (6.0
kgf-m, 43.5 lb-ft)
3
(a)
9) Install timing chain with crankshaft sprocket referring
to "Timing Chain and Chain Tensioner Removal and
Installation".
10) Install timing chain cover referring to "Timing Chain
Cover Removal and Installation".
11) Check valve lashes referring to "Valve Lash
(Clearance) Inspection".
12) Perform Steps 10) to 14) of "Installation" of "Timing
Chain Cover Removal and Installation".
Engine Mechanical: 1D-35
1
2
I3RH0B140042-01