Suspension Control Arm / Bushing Disassembly And Assembly - Suzuki 2006 SX4 Service Manual

2B-15 Front Suspension:
Installation
1) Install suspension control arm as shown but tighten
suspension control arm bolts (1) only temporarily.
CAUTION
!
Use new control arm bolt.
2) Install steering knuckle with front wheel hub referring
to step 7) to 17) of "Installation" under "Front Wheel
Hub, Steering Knuckle and Wheel Bearing Removal
and Installation".
3) Install wheel and tighten wheel nuts to specified
torque.
Tightening torque
Wheel nut: 85 N·m (8.5 kgf-m, 61.5 lb-ft)
4) Lower hoist and vehicle in unloaded condition,
tighten new control arm bolts to specified torque.
Tightening torque
Suspension control arm bolt (a): 95 N·m (9.5
kgf-m, 69.0 lb-ft)
5) Confirm front wheel alignment referring to "Front
Wheel Alignment Inspection and Adjustment".
1
1
I5RW0A220020-01
(a)
I5RW0A220021-01
Suspension Control Arm / Bushing
Disassembly and Assembly
Disassembly
1) Cut off bushing flange (rubber) (1) with knife.
2) Push out bushing by using hydraulic press (2) and
special tools.
Special tool
(A): 09943–76310
(B): 09913–75821
S6RW0D2206010
I4RS0B220019-01
2
(B)
(A)
I4RS0B220020-01