Suzuki 2006 SX4 Service Manual page 229

Terminal Wire
No. color
RED/
E01-26 EPS signal
BLU
E01-27 —
Serial
YEL/ communication line
E01-28
BLK for immobilizer coil
antenna
BLK/ Ignition switch
E01-29
WHT signal
Starting motor
E01-30 WHT
control relay output
E01-31 BLK Ground for ECM
Power supply of
E01-32 GRN throttle actuator
drive circuit
E01-33 —
Output for 5 V
E01-34 RED power source of
APP sensor (sub)
Output for 5 V
E01-35 BRN power source of
APP sensor (main)
APP sensor (sub)
E01-36 YEL
signal
APP sensor (main)
E01-37 GRN
signal
E01-38 —
E01-39 —
E01-40 —
E01-41 —
E01-42 —
E01-43 —
E01-44 —
Throttle actuator
E01-45 BRN
control relay output
Circuit Normal voltage
10 – 14 V
0 – 1 V
— —
10 – 14 V
0 – 1 V
10 – 14 V
0 – 1 V
0 – 1 V
Below 0.3 V
10 – 14 V
— —
4.5 – 5.5 V
4.5 – 5.5 V
0.37 – 0.38 V
1.70 – 2.00 V
("Reference
waveform No.30: ")
0.75 – 0.85 V
3.46 – 4.24 V
("Reference
waveform No.30: ")
— —
— —
— —
— —
— —
— —
— —
0 – 1 V
Engine General Information and Diagnosis:
Condition
Ignition switch turned ON.
With engine running at idle
speed, and steering wheel
turned to the right or left as
far as it stops.
—
Ignition switch turned ON.
Ignition switch turned OFF.
Ignition switch turned ON.
Ignition switch turned ON.
Ignition switch is turned to
ST (engine cranking)
position.
Ignition switch turned ON.
Ignition switch turned ON.
—
Ignition switch turned ON.
Ignition switch turned ON.
Ignition switch turned ON
and accelerator pedal at
idle position after warmed
up engine.
Ignition switch turned ON
and accelerator pedal at
full depressed position
after warmed up engine.
Ignition switch turned ON
and accelerator pedal at
idle position after warmed
up engine.
Ignition switch turned ON
and accelerator pedal at
full depressed position
after warmed up engine.
—
—
—
—
—
—
—
Ignition switch turned ON.
1A-179
Remarks
—
—
—
—
—
—
—
—
—
—
—
—
—
—
—
—
—
—
—
—