Suzuki 2006 SX4 Service Manual page 448

2B-11 Front Suspension:
15) Remove wheel bearing outside inner race (1).
Special tool
(A): 09913–65810
(B): 09913–85230
16) Remove hub bolts (1) with copper hammer or
hydraulic press.
CAUTION
!
Never remove bolt unless replacement is
necessary.
Be sure to use a new bolt for replacement.
Installation
For installation, reverse removal procedure, noting the
following instructions.
1) Face grooved rubber seal side (1) of new wheel
I7RW01220005-01
2) Install circlip (1).
1
3) Insert new hub bolt (1) in hub hole. Rotate hub bolt
I7RW01220006-01
bearing (2) upward as shown in figure and press-fit it
into knuckle (3) using special tool.
Special tool
(A): 09913–75510
(B): 09944–78220
(C): 09925–14520
CAUTION
!
Never reuse wheel bearing.
4. Encoder
slowly to assure that serrations are aligned with
those made by original bolt.
I5RW0A220016-01
I2RH01220037-01
1
I7RW01220015-01