Programming A Ptz Dome Camera; To Configure A Preset On A Ptz Camera - Honeywell rapid eye System Administrator Manual

To pan or tilt, move the mouse through the PTZ camera's window until the pointer changes to a
numbered arrow. Click. Figure 6–5 shows the Zonal Mode for panning left. For continuous
panning or tilting, click the arrow furthest from the center.
To stop continuous panning or tilting, move the mouse through the PTZ camera's window until
the pointer changes to an octagon. Click.
To zoom, use the wheel on the mouse. If the mouse does not have a wheel, see
Dartboard

Programming a PTZ Dome Camera

Fig. 6–6.
PTZ preset
Presets are set during a
when use of the camera ceases, when a Live session ends.
Auto-focus
View supports an auto-focus control when two dots appear in the "– Focus +" arc of the PTZ
controller. Click between the dots to toggle auto-focus ON/OFF. See figure 6–6.
Auto-iris
View supports an auto-iris control when two dots appear in the "– Iris +" arc of the PTZ controller.
Click between the dots to toggle auto-iris ON/OFF.

To Configure a Preset on a PTZ Camera

1. Continue or start a
2. Click the Video tab.
3. Click PTZ.
4. Select a camera whose PTZ preset you need to set.
Document 800-02325 Rev A
07/08
Control, above
PTZ Dome Camera without Auto-focus (1) or with, Between the Dots (2).
Maintenance Session. A PTZ camera can be set to return to the first preset
Maintenance Session.
System Administrator Guide
Using the
91