To Assign And Set A New Ptz Device; Video Tab Settings For Ptz - Honeywell rapid eye System Administrator Manual

Pan, Tilt, and Zoom (PTZ) Setup

To Assign and Set a New PTZ Device

1. Find out to which serial port on the Multi-Media unit is connected to the PTZ dome(s). The
installers connected the Data In port of domes (an RS-485 connector) to either:
One of the serial ports on a Rapid Eye unit. The port number for a dome can differ from that of
another dome.
A bus, connected to one of the serial ports on a Rapid Eye unit. The port number is the same
for the domes on that bus.
2. Continue or start a
3. Click the Serial Devices tab.
4. Expand the New Devices group.
5. Drag the PTZ icon to the Port that matches the unit's serial port identified in step 1. If you drop the
icon on a port that is already assigned to another device, the PTZ device displaces it; the
displaced device is sent to the Unassigned Devices group.
6. You have the option of renaming the device. Click the Device Name box and type. A maximum of
thirty-two characters and numbers are allowed, including spaces.
7. Select the serial interface protocol: RS–232, RS–485, or RS–422.
8. You have the option of:
Selecting the Enable Controller Switch. A checkmark sets the Multi-Media unit's OUTPUT 1 to
send a signal whenever a PTZ camera is selected during a Live session. Installers can connect
OUTPUT 1 to the external controller so that the signal disables the controller while a Multi-
Media operator uses a PTZ camera. When a PTZ camera is not selected, the signal from output
1 stops so that control of the PTZ serial bus is returned to the external controller.
Assigning another PTZ device to another Port (or to the Unassigned Devices group). To do so,
repeat steps 4 to 7.
ACUIX dome camera domes
For ACUIX dome camera domes, you have the option of using the Intellibus PTZ driver. See
Dome Camera, on p. 98.

Video Tab Settings for PTZ

Preparations
Assign a PTZ serial device, as explained in procedure
above. The device can be assigned to either:
One of the ports on the Multi-Media unit.
The Unassigned Devices group.
The signal format for all cameras (NTSC, PAL) is set on the System tab.
Tip
See System Tab in a Maintenance
Using many PTZ domes/cameras on one serial communications line
If more than one PTZ camera share the same serial communications line. If so, make a note of:
The address set on each camera.
86
Maintenance Session.
Session, p. 136.
To Assign and Set a New PTZ
ACUIX
Device,